ALL LABEL INSTRUCTIONS

SEW-ON NAME TAPES:

• • Use needle and thread
  • Labels are typically attached on left and right edges or corners

---

IRON-ON NAME TAPES:

• • Use dry iron, DO NOT use STEAM
  • Set IRON on cotton setting/high or up to 375°F. Iron MUST VERY HOT for labels to ADHERE
  • PRESS IRON DOWN firmly on label and HOLD for up to 8 seconds depending on material it is being applied to. (DO NOT REMOVE iron)
  • Suggested for flat surfaces
  
  

  SUGGESTED FOR:	NOT SUGGESTED FOR:
  - Cotton	- Nylon
  - Poly	- Silk
  - Cotton/Poly	- Delicate Fabrics

---

PERFORMANCE CLOTHING LABELS:

• • Set IRON to the WOOL setting/medium or up to 280°F. DO NOT use STEAM
  • Preheat the area you wish to apply the name label to. Iron the area for 4-5 seconds to remove any moisture from the garment for proper adhesion
  • TRIM a SINGLE label from the gang sheet, and remove the YELLOW backing. DO NOT REMOVE the label from the CLEAR carrier sheet
  • Once name label is applied, place your iron on top of it. Using medium pressure, press down for 4-5 seconds. DO NOT move the iron around
  • While name label and carrier sheet are STILL HOT, carefully peel the carrier sheet off of the garment leaving the label behind, and discard

---

PRESS ON CLOTHING & EQUIPMENT LABELS:

• • Clean surface
  • PRESS-ON firmly
  • For best results, allow adhesive to SIT for 24 hours
  • The BEST place for running shoes is under the tongue, or the arch of the foot
  • Print may fade if in direct contact with certain sunscreen products
  
  

  SUGGESTED FOR:
  - Equipment
  - Shoes
  - Care Tags of most garments

* We recommend laminating PRESS-ON labels to avoid fading or scratching from abrasive contact

---

APPAREL INSTRUCTIONS

GRAPHIC T-SHIRTS:

• • Wash inside out
  • Do not bleach
  • Tumble dry low